Training Collar Guide: Pick the training collar that best suits your pet

How an Electric Dog Fence Works

How An Electric Dog Fence Works

This is because the amount of space that an owner can give to his dog and the fact that the dog can not walk out of the perimeter without an electrical correction.

A wireless dog fence works on the principle that the owner gives the dog a certain amount of space to roam in. When the system is set up the beam can be adjusted by the owner and the dog can be trained to stay within the ray paths of the use of the techniques used in the system or training by the owner himself.

The dog will be required to have a special collar that a sensor in the perimeter set by the owner of the dog recognizes will have to bear.

You can always reduce the perimeter or in the invisible pet fence, so you can make your dog more “leash” or less, depending on your needs. This way you have a good system in place that allows your dog to roam freely within the perimeter, but you can always adjust the dog will be attached to your needs.

If you set the system by simply connecting to the mains and set your range you can start using.

At this point you should have already trained your dog with the instructions provided so that the dog will adhere to the border.

Now your dog’s new collar and let the dog run as much as it wants. Once the dog closes in on the edge of his territory will beep, which is transmitted from the collar to be. This teaches the dog that he is close to the edge and if he does not listen to the beep and wanders away and rejected in the zone, there will be an electrical correction.

These corrections are small electrical pulses to get the dogs attention and teach him that what he did was wrong. As long as your dog listening to the electronic or electrical signs will be no problems with the wireless electric dog fence for many years to come.

See invisible dog fence and indoor dog containment on http://ElectricDogFenceStore.com

More Articles Electric Dog Fence

Be Sociable, Share!

You can follow any responses to this entry through the RSS 2.0 feed.